DE
AGP3RParticle filter P3, RD40

Particle filter P3 with RD40 thread

Single filter of class P3 for the central threaded connection of the full-face mask AG700. With the full-face mask it is permitted up to 400 times the workplace exposure limit under DGUV Rule 112-190.

Marking
P3
Standard
EN 143:2021
Connection
RD40
Fits
AG700
PPE category
III, CE 2834
Packaging
20 pieces
View in the B2B shopRequest a quoteRequest samples

Data sheet (PDF)Instructions for use (PDF)Ask for advice

Warnings

  • Particle filters do not protect against gases and vapours.
  • Filters do not supply oxygen: do not use where the oxygen content may be too low (below 19.5 % by volume according to the instructions for use), in tanks, pits, shafts and confined spaces, or if the substance and its concentration are not known.
  • Use only with the AirGuard Pro masks named in the documents.

The instructions for use of the product are authoritative.

AirGuard Pro Particle filter P3, RD40 AGP3R, black

For the full-face mask only

Only the full-face mask AG700 has an RD40 round thread in the AirGuard Pro range. Before screwing in, the bayonet connections at the sides stay closed; only one filter system is ever used. For the half masks there are the bayonet filters AGP3R1 and AGP3R2.

Particles, no gases

P3 retains dust, smoke and mist, but not gases and vapours. If both occur, the RD40 thread takes the combination filters AGA2E2 (A2E2P3) and AGABEK2P3 (A2B2E2K2P3).

According to the instructions for use the filter may be used beyond one shift; store airtight between uses. Replace when breathing becomes noticeably harder, the filter is damaged or the expiry date is reached.

Using correctly

  1. 01

    Open only at the place of use

    Take the filter out of its packaging immediately before use and check the expiry date on the filter.

  2. 02

    Screw in centrally

    Keep the side connections of the AG700 closed and screw the filter clockwise into the RD40 thread until tight.

  3. 03

    Check the face seal

    Place the palm of your hand over the exhalation valve and exhale slowly. If air escapes at the edge of the mask, reposition it and tighten the straps. Before every use.

  4. 04

    Replace in good time

    When breathing becomes noticeably harder or the filter is damaged.

When filters are replaced

Technical data

Technical data AGP3R
Article numberAGP3R
TypeParticle filter
Colourblack
StandardEN 143:2021
MarkingP3
Particle filterP3
ConnectionRD40 thread, one filter
FitsAG700
PPE categoryIII under Regulation (EU) 2016/425
Notified bodyCCQS Certification Services Limited, 2834
Packaging20 pieces, each in a box

Downloads

Declaration of conformity on request: Request documents

Frequently asked questions

Does the AGP3R fit the half mask AG360?

No. The AG360 has bayonet connections. The AGP3R with RD40 thread only fits the full-face mask AG700.

How long can I use the AGP3R?

According to the instructions for use beyond one shift, airtight between uses. Replace when breathing becomes noticeably harder, the filter is damaged or the expiry date is reached.

One filter in the centre or two at the sides?

Both are possible on the AG700, but never at the same time. More under Bayonet or RD40.

Goes with it

To the respirator finder

The brand family of DS SafetyWear Arbeitsschutzprodukte GmbH